Skip to main content

Reaching Condition Techniques for Mitigation of Chattering In Sliding Mode Controlled Buck Converter


Volume 5 Issue 4 September - November 2017
Article
K.B. Siddesh*, Basavaraja **
* Associate Professor, Department of Electronics and Communication Engineering, SJMIT, Chitradurga, India.
** Professor and Chairman, Department of Electrical and Electronics Engineering, UBDTCE, Davangere, India.
Siddesh, K. B. and Banakara, B. (2017). Reaching Condition Techniques for Mitigation of Chattering in Sliding Mode Controlled Buck Converter. i-manager’s Journal on Circuits and Systems, 5(4), 33-38. https://doi.org/10.26634/jcir.5.4.13943
Abstract
This paper presents a reaching condition methods for Sliding Mode Controlled DC-DC Buck Converter. Three approaches are specified for reaching conditions. The approaches comparing among the chattering, which is effectively reduced the chattering and fast speed is kept. The approaches are direct switching, lyapunov and reaching law approach. Among them reaching law approach minimizes the chattering and effective output is obtained. Various output voltages are obtained by keeping V as constant and chattering is analysed, minimized and also takes very less ref time to reach the steady state. A simulation results shows better reduction of chattering by the reaching law.

Comments

Popular posts from this blog

Fuzzy Based Power Quality Improvement In Grid Connected Microgrid At The Distribution Level

Volume 1 Issue 2 March - May 2013 Research Paper Fuzzy Based Power Quality Improvement In Grid Connected Microgrid At The Distribution Level Naveen Bolisetti*, Mothiram Bhukya** * Department of Electrical and Electronics Engineering, SRKR Engineering college, Bhimavaram, Andhra Pradesh, INDIA. ** Department of Electrical and Electronics Engineering, SRKR Engineering college, Bhimavaram, Andhra Pradesh, INDIA. Bolisetti, N., and Ram, M. B. (2013). Fuzzy Based Power Quality Improvement In Grid Connected Microgrid at the Distribution Level.  i-manager’s Journal on Circuits and Systems , 1(2), 1-6.  https://doi.org/10.26634/jcir.1.2.2288 Abstract This paper suggests a new control strategy that consists of a grid interfaced four leg inverter control system using adaptive fuzzy controller for a 3-phase 4-wire distribution system that is capable of simultaneously compensating problems like power factor, current imbalance and current harmonics, and also of inject...

Design and Implementation of Low Power ALU Using 8T Full Adder with FinFETs

Volume 5 Issue 4 September - November 2017 Research Paper Design and Implementation of Low Power ALU Using 8T Full Adder with FinFETs M. Chandra Sekhar Reddy*, P. Ramana Reddy** * Research Scholar, Department of Electronics and Communication Engineering, JNTUA, Anantapuramu, Andhra Pradesh, India. ** Professor, Department of Electronics and Communication Engineering, JNTUACEA, Anantapuramu, Andhra Pradesh, India. Reddy, M. C. S., and Reddy, P. R. (2017). Design and Implementation of Low Power ALU Using 8T Full Adder with FINFETS.  i-manager’s Journal on Circuits and Systems , 5(4), 8-14.  https://doi.org/10.26634/jcir.5.4.13939 Abstract An Arithmetic and Logic Unit (ALU) is an advanced circuit that performs number-crunching and rationale operations. ALU is an essential building piece of the focal preparing unit of a PC. The power, devoured by the ALU has a direct effect on the power disseminated from the processor. Thus, a plan is required to execute the ...

Power Efficient Functional Units for High Speed Computations

Research Paper Power Efficient Functional Units for High Speed Computations B. Dinesh*, R. Jagadeesh**, M. Kathirvelu*** *,** PG Students, Department of ECE, KPR Institute of Engineering and Technology, Coimbatore, Tamil Nadu, India. *** HOD & Professor, Department of Electronics and Communication, KPR Institute of Engineering and Technology, Coimbatore, Tamil Nadu. Dinesh, B. Jagadeesh, R. and Kathirvelu, M. (2013). Power Efficient Functional Units For High Speed Computations.  i-manager’s Journal on Circuits and Systems , 1(3), 13-18.  https://doi.org/10.26634/jcir.1.3.2443 Abstract Power consumed per unit switching activity in a CMOS based computational unit is greatly dependent on the power consumption of the sum and carry generation units. This paper is focussed on reducing area and PDP of the computational units through gate level and transistor level optimisation. At transistor level 6T Mux based CMOS-CPL XOR gates with stable rise and fall times ar...