Skip to main content

Fault Analysis of Stationary and LFM Signals Using Wavelet Transform


Volume 3 Issue 3 June - August 2015
Research Paper
Fault Analysis of Stationary and LFM Signals Using Wavelet Transform
A. Naga Jyothi*, M. Rajeswari**
* Associate Professor, Department of Electronics and Communication Engineering, Vignan's Institute of Information Technology, Visakhapatnam, Andhar Pradesh, India.
** Assistant Professor, Department of Electronics and Communication Engineering, Vignan's Institute of Information Technology, Visakhapatnam, Andhar Pradesh,India.
NagaJyothi, A., and Rajeswari, M. (2015). Fault Analysis of Stationary and LFM Signals Using Wavelet Transform. i-manager’s Journal on Circuits and Systems, 3(3), 25-29. https://doi.org/10.26634/jcir.3.3.4782
Abstract
The fault analysis of sine and linear frequency modulated signals using wavelet transform is proposed in this paper. By using the wavelet transform, the time-frequency localization characteristics and the frequency information of waveform can be integrally obtainable. This approach is more efficient in monitoring the time-varying disturbances when compared with those of fourier transform based methods. In this paper, the result analysis shows how the decomposition of sine and linear frequency modulated signals has been carried out by using wavelet transform.

Comments

Post a Comment

Popular posts from this blog

Continuous Overvoltage Characteristics of Surge Protected Power Strips

Volume 5 Issue 4 September - November 2017 Research Paper Continuous Overvoltage Characteristics of Surge Protected Power Strips Cengiz Polat* Assistant Professor, Department of Electrical and Electronics Engineering, Istanbul University, Istanbul, Turkey. Uzunoglu, C. P. (2017). Continuous Over Voltage Characteristics of Surge Protected Power Strips.  i-manager’s Journal on Circuits and Systems,  5(4), 1-7.  https://doi.org/10.26634/jcir.5.4.13938 Abstract Increasing applications of constantly developing electronic devices require delicate voltage and current protection. Although the electrical network is monitored continuously, undesired over currents and over voltages may occur on the distribution system due to failures. Most of the electronic switch gear is connected via surge protected power strips in indoor applications, where current protection is vital. Surge protected power strips are usually manufactured based on Metal Oxide Varistors (MOVs) ...
Post a Comment
Read more

Reduced Wirelength-Based Low Power Performance of Multibit Flip-Flop

Volume 1 Issue 4 September - November 2013 Research Paper Reduced Wirelength-Based Low Power Performance of Multibit Flip-Flop M.Karthick*, S. Vijayakumar** *PG Scholar, Department of Electronics and Communication Engineering, Paavai Engineering College, Namakkal, India. **Associate Professor, Department of Electronics and Communication Engineering, Paavai Engineering College, Namakkal, India. Karthick, M. and Vijayakumar, S. (2013). Reduced Wire length-Based Low Power Performance Of Multibit Flip-Flop.  i-manager’s Journal on Circuits and Systems , 1(4), 22-26.  https://doi.org/10.26634/jcir.1.4.2593 Abstract Power reduction is a main parameter to design VLSI circuits. In this paper, to design a number of D-flip flop performing at the same time, the given clock signal is reduced using multi bit flip-flop. The multi bit flip flop is mainly used to improve the clock power for the given common clock signal and to reduce the switching power. This method is p...
Post a Comment
Read more

A Review on Control strategies for LFC in Deregulated Scenario

Volume 1 Issue 1 December - February 2013 Review Paper A Review on Control strategies for LFC in Deregulated Scenario T. Anilkumar*, N. Venkata ramana** * Associate Professor, EEE Department, ACE Engineering College, Ghatkesar, Hyderabad, AP, India. ** Professor and Head of Deportment, EEE Department, JNTU Mantini, AP, India. Kumar, T. A., and Ramana, N., (2013). A Review On Control Strategies For LFC In Deregulated Scenario.  i-manager’s Journal on Circuits and Systems , 1(1), 27-36.  https://doi.org/10.26634/jcir.1.1.2197 Abstract In power system studies, Load frequency control is an important issue to supply sufficient and reliable electric power with good quality. The main objective of LFC is to maintain load frequency and tie-line power flow within permissible limits by adjusting megawatt output of LFC generators, so as to accommodate fluctuating load demands. This paper presents a brief review of different control techniques to researchers on design...
Post a Comment
Read more